Buttercub baby pattern

1-1

 

GARTER ST (back and forth on needle): K all rows.

SHORT ROWS:
* Work 2 rows in garter st over the 24-24-26 (28-28) band sts, work 2 rows in garter st only over the outermost 12-12-13 (14-14) sts. NOTE: When turning mid piece, slip first st. Tighten thread and continue as before. This is done to avoid holes in the transitions *.

BUTTON HOLES:
The jacket is double-breasted. Cast off for 4 button holes on right band.
1 BUTTON HOLE = K tog fourth and fifth st from edge and make 1 YO. On same row also K tog fourth and fifth LAST st on band, make 1 YO.
Cast off for 2 button holes when piece measures:
SIZE 1/3 MONTHS: 14 and 19 cm
SIZE 6/9 MONTHS: 16 and 21 cm
SIZE 12/18 MONTHS: 18 and 24 cm
SIZE 2 YEARS: 20 and 27 cm
SIZE 3/4 YEARS: 22 and 30 cm

———————————————————-
JACKET:
Worked back and forth on circular needle.
Beg on front piece, cast on sts for sleeve and work up to the shoulder. Knit the other front piece, place both front pieces tog and work down the back piece.

LEFT FRONT PIECE:
Read all of the following section before continuing!
Cast on 43-47-51 (56-59) sts (incl 1 edge st in the side and 24-24-26 (28-28) band sts towards mid front) on needle size 2.5 mm with Baby Merino. Work 6 rows in GARTER ST – see explanation above. Switch to circular needle size 3 mm and work in stocking st but continue to work the 24-24-26 (28-28) band sts towards mid front in Garter st. When piece measures 4 cm, work SHORT ROWS – see explanation above (1st row = from WS). Repeat from *-* 1 time every 4 cm until piece measures 19-21-24 (27-30) cm, then repeat from *-* 1 time every other cm until finished measurements.
AT THE SAME TIME when piece measures 16-17-20 (23-25) cm, cast on new sts at the end of every row from WS (towards the side of sleeve): 6 sts 2-2-3 (3-3) times, 8 sts 1-1-1 (2-3) times and 21-22-22 (25-26) sts 1 time = 84-89-99 (115-127) sts for shoulder/sleeve.
Work inc sts in stocking st. When all sts have been cast on, continue in stocking st and Garter st as before while AT THE SAME TIME also working the outermost 10 sts on sleeve in garter st.
When piece measures 27-29-33 (37-40) cm, insert a marker = mid on top of shoulder. Now slip the 24-24-26 (28-28) band sts towards mid front on a stitch holder. Then cast on 2 new sts at the end of row from RS (towards neck), repeat inc on next row towards neck = 64-69-77 (91-103) sts on needle.
Work 1 row from WS.
Put all sts on a stitch holder.

RIGHT FRONT PIECE:
Cast on and work as left front piece but reversed. In addition cast off for BUTTON HOLES on band – see explanation above. NOTE! Slip sts on a stitch holder after the last row with inc (i.e. last row = from WS).

BACK PIECE:
Work left front piece on to circular needle, cast on 16-16-18 (20-20) new sts (= back of neck) and work right front piece on to circular needle = 144-154-172 (202-226) sts.
NOW MEASURE PIECE FROM MARKERS ON SHOULDERS.
Continue in stocking st and Garter st at the end on each sleeve back and forth on needle.
When piece measures 8½-9½-10 (10-11) cm, beg to cast off sleeve sts. Cast off at beg of every row in each side as follows: 21-22-22 (25-26) sts 1 time, 8 sts 1-1-1 (2-3) times and 6 sts 2-2-3 (3-3) times = 62-70-76 (84-90) sts on needle. Continue in stocking st with 1 edge st in each side.
When piece measures approx. 26-28-32 (36-39) cm – fold the piece double at the markers on shoulders and make sure that the back piece is as long as front piece down to rows in garter st, switch to needle size 2.5 mm and work 6 rows in garter st, then cast off.

ASSEMBLY:
Sew the sleeve and side seams inside 1 edge st. Sew on buttons.

HOOD:
Knit up approx. 102-106-112 (118-122) sts (incl sts from stitch holders at the front – NOTE: If more/fewer sts have been knitted up, dec/inc evenly on 1st row. Continue in garter st over all sts while AT THE SAME TIME working short rows in each side every other cm – SEE EXPLANATION ABOVE. Cast off when hood measures approx. 21-23-25 (27-28) cm. Sew hood neatly tog at the top – sew in front loop of outermost st to avoid a chunky seam.

CROCHET BORDER:
Crochet a border around the entire jacket.
Beg at the bottom on right front piece and crochet with 2 threads yellow Baby Merino and hook size 3 mm as follows:
Work 1 dc, * 3 ch, 1 tr in 1st ch, skip approx. ½ cm, 1 dc in next st *, repeat from *-*.
Crochet the same way around the openings on sleeves.
—————————————————————–

SLIPPER:
The slipper is worked back and forth from mid back. Cast on 48-52-56 (56) sts on needle size 2.5 mm with 2 threads yellow Baby Merino. Remove 1 thread and work rib (= K 2/P 2) for 5-6-6 (7) cm – adjust so that next row is worked from WS. P 1 row from WS while at the same time dec 14-14-18 (14) sts evenly = 34-38-38 (42) sts. On next row work eyelet holes as follows from RS: K 1, *K 2 tog, 1 YO *, repeat from *-* and finish with K 1. P 1 row from WS. Now slip the outermost 12-13-13 (15) sts in each side on a stitch holder. Work 4 – 4½ – 5½ (6½) cm in stocking st over the middle 10-12-12 (12) sts. Slip sts from stitch holders back on needle and knit up 10-11-13 (16) sts on each side of mid piece = 54-60-64 (74) sts on needle. K every row over all sts for 3-4-5 (5) cm while at the same time after 1½ – 2 – 2½ (3) cm, dec on every other row as follows until completed: Dec 1 st at the beg and the end of row and K 2 tog on each side of the 2 mid sts. Cast off and sew tog mid under foot and continue up mid back in front loop of outermost sts to avoid a chunky seam.
Knit another slipper the same way.

TIES:
Cut 3 threads light yellow of approx. 1 metres, twine them tightly tog, fold them double and they will twine again, tie a knot in each end. Thread tie up and down through the eyelet holes on slipper.

CROCHET BORDER:
Crochet a border at the top of slipper on hook size 2 mm with light yellow as follows: 1 dc in first st, * 3 ch, 1 tr in 1st ch, skip approx. ½ cm, 1 dc in next st *, repeat from *-* and finish with 1 sl st in dc from beg of round.

Kitsap from Berroco for woman

kitsap_lg kitsap_D_lg

Kitsap

Skill level:  Easy

Shown in size Small

Sizes

Directions are for women’s size X-Small.  Changes for sizes Small, Medium, Large, 1X and 2X are in parentheses

To Fit Bust Size:  30(34-38-42-46-50)”

Finished measurements

Bust (closed) – 32(36-40-44-48-52)”
Length – 28(28-29-29-30-30½)”

Note:  This garment was designed with approximately 2” of ease.  Please take this into consideration when selecting your size.

Materials

8(9-11-12-13-14) Balls Berroco LodgeKITSAP(1)-800x1035 (50 grs), #7446 Crater Lake

Straight knitting needles, size 10 (6.00 mm) OR SIZE TO OBTAIN GAUGE

29″ Length circular knitting needle, size 10 (6.00 mm)

Gauge

14 sts = 4″;  20 rows = 4″ in St st

TO SAVE TIME, TAKE TIME TO CHECK GAUGE

Back

With straight needles, cast on 57(65-71-79-85-93) sts.  Work even in Garter St for 1″.  Work even in St st until piece measures 19(19-19½- 19½- 20-20)” from beg, end on WS.

Shape Armholes:  Bind off 3(3-4-4-5-5) sts at beg of the next 2 rows, then 2 sts at beg of the following 2 rows – 47(55-59-67-71-79) sts.  Dec 1 st each side every RS row 2(4-5-7-7-9) times – 43(47-49-53-57-61) sts.  Work even until armholes measure 8(8-8½- 8½-9-9½)”, end on WS.

Shape Shoulders:  Bind off 3(3-4-4-6-6) sts at beg of the next 2 rows, then 3(4-4-5-5-6) sts at beg of the next 4 rows.  Bind off remaining 25 sts for back neck.

Left front

With straight needles, cast on 29(33-36-40-43-47) sts.  Work even in Garter St for 1″.  Work even in St st until piece measures 17(17-17½- 17½- 18-18)” from beg, end on WS.  Mark beg of last row for beg of neck shaping.

Shape Neck:  Next Row (RS):  K to last 3 sts, SSK, k1 – 28(32-35-39-42-46) sts.  Rep this dec every 3/4″ 12 times more.  AT THE SAME TIME, when piece measures 19(19-19½- 19½- 20-20)” from beg, end on WS.  Shape armhole same as back.  When all decs have been completed, work even on 9(11-12-14-16-18) sts until armhole measures 8(8-8½- 8½- 9-9½)”, end on WS.  Bind off 3(3-4-4-6-6) sts at armhole edge once, then 3(4-4-5-5-6) sts twice for shoulder.

Right front

Work to correspond to left front, reversing all shaping.  Work neck decs at beg of RS row as k1, k2 tog.  Bind off for armhole on WS rows.  Work armhole decs at end of RS rows.  Bind off for shoulder on WS rows.

Sleeves

With straight needles, cast on 32 sts.  Work even in Garter St for 1″.  Work in St st, inc 1 st each side every 3¼(2¼- 1¾- 1½- 1¼- 1)” 5(7-9-10-12-14) times – 42(46-50-52-56-60) sts.  Work even until sleeve measures 18″ from beg, end on WS.

Shape Cap:  Bind off 3(3-4-4-5-5) sts at beg of the next 2 rows, then 2 sts at beg of the following 2 rows – 32(36-38-40-42-46) sts.  Dec 1 st each side every RS row 11(11-11-11-12-12) times, end on WS.  Bind off 1(3-2-3-3-3) sts at beg of the next 2 rows.  Bind off remaining 8(8-12-12-12-16) sts.

Finishing

Sew shoulder seams.  Sew in sleeves.  Sew side and sleeve seam.

Front/Neckband:  With RS facing, using circular needle, beg at lower right front edge, pick up and k84(84-88-88-92-96) sts along right front and neck edge to shoulder seam, 26 sts across back neck edge, then 84(84-88-88-92-96) sts along left front and neck edge to lower edge – 194(194-202-202-210-218) sts.  Knit 5 rows, end on WS.

Next Row (RS):  Bind off 39 sts, k to end – 155(155-163-163-171-179) sts.

Following Row:  Bind off 19 sts, k to end – 136(136-144-144-152-160) sts.  Work even in Garter St until collar measures 3½” from picked-up edge, end on WS.  Bind off.